How to use a Node?
Posted: 25 Dec 2017, 20:29
I followed the directions in the documentation to install it. I believe it is operational per Settings -> Nodes. However, I do not see any documentation to show me how to stream music to it. I see the Node selection under Players, but it is always greyed out. Under Settings -> Nodes, I see a variety of different buttons for Open, Start, Pause, Resume, Skip, Stop, Transfer & Config.
Looking for some information on basic functionality at this point, even if it is experimental. I am building a RPi3 Jukebox with a Schiit Modi 2 Uber USB DAC. It worked great hosting the Madsonic Server itself on the RPi3, but I would likely prefer the RPi3 to just be a Node rather than the entire Madsonic Server itself.
I don't mind if the full functionality is not there for awhile, but I would prefer not to stream the music from Madsonic directly Chromium as a workaround. Thank for your work on this product -- I do enjoy it.
Looking for some information on basic functionality at this point, even if it is experimental. I am building a RPi3 Jukebox with a Schiit Modi 2 Uber USB DAC. It worked great hosting the Madsonic Server itself on the RPi3, but I would likely prefer the RPi3 to just be a Node rather than the entire Madsonic Server itself.
I don't mind if the full functionality is not there for awhile, but I would prefer not to stream the music from Madsonic directly Chromium as a workaround. Thank for your work on this product -- I do enjoy it.